CJ DESIGNS AXLE PUSHER 30 MM
|
|
|
|
|
- Item #: AP
CJ Designs Axle Pusher
This fits most 950/990 KTM front axles: Adventure, Super Moto, Super Duke. It does not fit the 950 Super Enduro or KTM full size dirt bikes. See the 26 mm version in related items below for that version.
This small addition to your tool kit can help save time and expensive damage to you stock front axle.
DON'T grab that Hammer and Punch first!!
Some pullers can make your axle oval when tightened up. This makes the axle harder to remove.
In your stock KTM LC8 tool kit you should have a 17mm socket, the same one used on my Spark plug wrench. Use this to thread it into the axle. If you don't, your fingers will work too. Thread it in a few turns.
PUSH or tap on the end of your "T" handle with a small rock or hammer.
This will save the axle threads from any damage caused by a punch.
If you don't have the 17mm socket, the end of your "T" wrench will work too.
When you reinstall the axle, add some grease or a small amount of engine oil off your dipstick if on the trail.
Available in Orange Anodized only
